BHI HydroRam HK300S, Operations Manual & Parts List

Page: 10 / 51

BHI
Best Hammer Industries
- 7 -
hammer should not be put into operation.
Apply grease at least once a day. Grease the tool bit at least every 2 or 3 hours more
often if the tool becomes dry or material is extremely dusty or abrasive, using hand grease
pump. Pump 5 - 10 times. When changing tool, clean and grease the shank bore. Insufficient
greasing may cause abnormal wear of the tool holder bushing and tool, and tool breakage.
Injury or death can result from improper operation or maintenance.
Please read and understand this Operation Manual!!!
Preserve the environment !!!
When dispose of the waste Hydraulic Hammers, obey all local, state of federal regulation
for the industrial waste.
Ⅲ. WARRANTY
Warranty period is six(6) month. Below parts are wear parts. These parts are not covered by
the warranty.
Wear parts : Diaphragm, backup ring, buffer ring, o-ring, round bushing, stop pin, spring
pin, tool holder bushing, retainer pin, tool and seal kit sets.
The warranty condition could be changed by individual contract, but it should be confirmed
in writing by BHI in advance.
1. The followings are not covered by warranty.
․ Normal wear and tear of the hammer and any part thereof
․ Failure, damage or defective condition due to:
- overloading, negligence or improper installation, use or operation which are is not
accordance with BHI's published instructions or its authorized distributors.
- improper repair, alteration or adjustment made to Hydraulic hammer or its parts.
- use of unauthorized parts, fluids or tools.
- corrosion or failure to protect from adverse environmental conditions.
- faulty or improper condition of the carrier on which the hydraulic hammer was installed.