BH FITNESS Swing Riding BS999, User Manual, Page: 9 / 11

9
Maintenance Chart
No DESCRIPTION Daily Weekly Monthly Quarterly Annually
1
Keep machine clean: Wipe machine down
with clean & dry fabric to clear dirt &
sweat.
X
2
Wipe Anti-rusty cream or similar on the
seat post set, handlebar set
X
3 Visual check X
4
Check security of handle bar post & seat
post
X
5 Check security of saddle X
6 Remove handlebar post and clean tube X
7 Remove seat and clean tube X
8 Check brake pads for wear-align X
9 Check brake adjustment X
10 Check security of all knobs & release lever X
11 Check toe straps for signs of wear X
12 Check crank bolts and re-tighten X
13 Make sure pedals are screwed in X
14 Check cushion X
15 Check belt tension X
16 Keep flywheel clean. X
17 Check bottom bracket X
18 Check flywheel bearings X
19 Full service-frame inspection X
※
Cushion and belt was consumables, will loosen or wear according the frequency of use. Warranty time : 6 months.
※
Adjusting the belt tension – the belt belongs to the flexible material. It will relax with frequency of utilization and time. It’s
normal situation.
1)
Loosen the bolt (32)(42), and take off the outer chain guard (6) and front chain cover (33).
2)
Loosen the nut (25).
3)
Rotating the nut of adjuster bolt (44) by clockwise and anti-clockwise to adjusting the belt tension. Suggest rotating 1/4 of the
circles each time. Don’t rotations too much to causing tension too tight then damage the axle and bearing.
4)
Make sure flywheel keeps parallel with frame. And two sides distance between flywheel and magnet must be the same.
5)
After finished the above steps, screw the nut by both sides. Make sure the nut is tighten and fixedly.
※
How to replace magnetic holder :
1)
Turning resistance knob to overall resistance, then return 1/4 of the circles. Make sure brake pad touch flywheel
completely. Then re-tighten the screw and nut (19). Make sure two sides of magnetic holder are symmetrical and in
the center of flywheel. Prevent the magnet touch the surface of flywheel. Then tighten the screw and washer (35).