BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Art. 9388
Plastic Repair Set with Gas Soldering Iron
GENERAL INFORMATION
This plastic welding equipment allows for economical repair of plastic parts, such as bumpers, inner wheel
arches, headlamp housings, engine covers or motorcycle fairings. The equipment has been designed to
remove minor to medium-sized damage. Even thin plastic parts can be welded, as the heat applied is
restricted to a small area. Compared to many other machines on the market, the advantage of this
equipment is that the exhaust gases are diverted in the welding direction which, in turn, accelerates the
heating of the material. The plastic welding equipment is supplied with two welding heads of different
sizes, reinforcing stainless steel fabric and plastic welding rods, suited for acrylonitrile butadiene styrene
(ABS), polypropylene (PP), polyethylene (PE) and polystyrene (PS), including a cleaning brush and
cleaning rod.
Our products are designed for their intended use only and are to be handled carefully.
BGS technic assumes no liability for material damage and injuries caused by improper use, in which case
the warranty is voided also.
Please carefully read the operating manual and safety instructions.
SAFETY INSTRUCTIONS
•
Improper use of the plastic welding equipment may lead to fire and injuries.
•
Keep all body parts away from the welding head. Caution: Risk of burns.
•
Never leave plastic welding equipment unattended when switched on.
•
Keep the plastic welding equipment dry and never cool down the welding head in water.
•
The plastic welding equipment contains pressurised combustible gas, therefore handle with extreme
care.
•
Never fill the equipment near a naked flame or combustible materials.
•
Do not keep the equipment near a naked flame.
•
Only use high-quality butane gas.
•
Caution when handling butane gas, as butane is inflammable.
•
Do not drop the equipment.
•
Do not open the equipment and do not make modifications to the equipment.
•
Do not use the equipment at temperatures above 50°C.
•
Store the equipment in a dry and cool place.
•
Keep the equipment out of the reach of children.
•
Let the equipment welding equipment cool down completely before putting it back in the protective
case.
•
Please note: No liability is assumed for improper use of the plastic welding equipment.
•
Use the equipment in well-ventilated places only.
•
Do not use the equipment if it is damaged or shows any wear of the seals.
•
Do not use the equipment if it is not working properly.
•
Please note that butane flames are hardly visible under certain lighting conditions.
•
Always keep a fire extinguisher and a bucket of water ready near the working area.
•
Let the equipment cool down sufficiently after use before leaving it unattended.
