16
-
ICARO Ver. 03
D811310_03
INSTALLATION MANUAL
ENGLISH
In case of scrapping, the automation devices do not entail any particular risks
or danger. In case of materials to be recycled, these should be sorted out by
type (electrical components, batteries, copper, aluminium, plastic etc.).
21) DISMANTLING
When the automation system is disassembled to be reassembled on
another site, proceed as follows:
•
Disconnect the power supply and the entire electrical installation.
•
Remove the gearmotor from its fixing base.
•
Disassemble the control panel, if separate, and all installation
components.
•
In the case where some of the components cannot be removed or are
damaged, they must be replaced.
22) MALFUNCTIONS AND REMEDIES
22.1) Faulty actuator operation
• Use an appropriate instrument to check that the actuator ends are
supplied with voltage after the opening or closing command.
• If the leaf movement is opposite to that required, reverse the motor drive
connections in the control unit.
22.2) Faulty operation of electrical accessories
In case of fault, all the control and safety devices can cause the automation
controller to malfunction or lock. If the control unit is provided with self-
diagnosing facility, identify the fault. If a fault is found, it is advisable to
disconnect and, if necessary, bridge, all the automation control devices one
by one, until the one causing the fault is identified. Replace or repair it, then
reset all the devices which were previously disconnected or bridged. For all
the devices installed, make reference to the respective instruction manual.
WARNING! Correct controller operation is only ensured when the data
contained in the present manual are observed. The company is not to
be held responsible for any damage resulting from failure to observe
the standards relating to safety, installation and good technical
practice, as well as the instructions contained in the present manual.
The descriptions and illustrations contained in the present manual
are not binding. The Company reserves the right to make any altera-
tions deemed appropriate for the technical, manufacturing and com-
mercial improvement of the product, while leaving the essential
product features unchanged, at any time and without undertaking to
update the present publication.
Summary of Contents for ICARO
Page 2: ...2 ICARO Ver 03 D811310_03 ...
