Wallmount set for
AT71 and AT91 antenna
- adjustable to any angle by special swivel joint assembly
SAFETY INSTRUCTIONS
MANUAL
Please check if all the components are there and o.k.
1. Thread adaptor 3/8" - 5-8" - 2. wing screw M6 x 15 mm - 3. swivel joint - 4. grub screw M6 x 8 mm -
5. wallplate with tube
WALL MOUNTING
SWIVEL JOINT ASSEMBLY
1. Place wall plate
5
1.
vertically.
2. Mark the drill holes.
3. Drill the holes for the
3.
wall plugs, 4x
3.
-ø 6 for anchor bolts
3.
-ø 8 for dowels
A
C
B
- For indoor use only
- Choose a position and mounting method compliant with
-
local building codes and regulations
- Use four anchors per wall bracket
- For use only by trained installers
- Only for use at proper walls with adequate anchors
-
(see B; not included in delivery)
- Not suitable for fragile walls. Beware of power suplly lines
-
and water conduits. In case ask an expert.
- Inspect bolted assemblies regularly.
- Keep the grub screw
4
tightened; only loosen the
-
screws while adjusting the speaker
Concrete wall
e.g.: bolt anchor M6 x 65 mm
drill a hole, blow debris from the hole, drive in
the anchor, position a washer and screw in the
bolt
Perforated brick
e.g.: plastic frame anchor 8 x 80 mm with
e.g.:
wood screw 6 x 85 mm
drill a hole, blow debris from the hole, drive in the rawl
plug, position the wall plate, connect with a screw and
an intermediate washer
Push swivel joint
3
over the tube.
Tighten grub screw
4
with allen wrench and wing screw
2
by hand
allen
wrench
SW3
not included
