Chapter 4. Door Station Installation
IP Video Door Station DS06M(P) Installation User Manual
11
4.2. Installation Recommendations
This paragraph contains a short list of recommendations necessary for the correct
installation of DS06M(P).
IP Video Door Station DS06M is installed in the dry places on the surface of the inactive
leaf of exterior double doors or on the wall of the building. It is recommended to install the device
indoors (vestibules, entrance halls), avoiding the outside installation. It is also recommended to lay
cables in an ergonomic way.
Install the door station in a well-lighted area avoiding exposure of the camera lens to direct
sunlight. The mounting height must be convenient for the Guest to talk with the Client. It is
recommended to install the door station at height of about 1.5 m from the floor.
Then it is recommended to provide the uninterrupted power supply of router, door station,
electronic lock and its controller.
Recommendations for door station placement:
The operating temperature range is -40
°С to +50°С.
Avoid exposure to direct sunlight and do not locate the door station near any heat
sources.
Incorrect installation may cause undesirable “blind spots
Do not locate the door station near any electrical appliances which can be
electromagnetic transmitters.
When installing the door station, make sure the cables are laid in a safe and ergonomic
way..
Avoid unstable installation, which may allow exposure to high vibration. This may reduce
motion detection performance and image quality in general.
The view direction should be clearly determined at the moment of the door station
installation.