6
3.3.6 Make sure that the specimens, vacuum test platform (or glass test platform) is clean, place the
applicator or wire bar coater smoothly, and then put the paint in front of the applicator.
3.3.7 Make sure that all the testing condition is ready, click the “Start” button to start testing.
3.3.8 Press “Stop” button to end the testing, the machine will stop when the stroke length is
reaching the setting stroke length.
3.3.9 Press “Return” button and take out the base material to have the next testing.
3.4 Parameter Setting
Run settings can set the running parameters:
1)
Open this setup interface, which can quickly set coating speed, return speed, film length and size,
etc.
1.1
The coating speed is the same as the coating speed set by the main interface, which can change
the pushing speed of the applicator. The unit is mm/s;
1.2
The return speed can change the return speed of the push rod after returning to the position
when the coating is finished, the unit is mm/s;
1.3
Coating size, you can set the film length of the film applicator, the range is 5 - 250mm, users
can click the "Edit" button to modify the film length according to their needs.
2)
Coating thickness, it can record the film thickness of the current applicator, click the edit and
amend the record;
3)
Coatings name, click Edit to change and select different paints. Different paints will save the
current set information of speed size and thickness and viscosity, so that it can be used for the next
time. and the paint name can be modified (Maximum 6 coating can be recorded).
4)
Viscosity, it can record the viscosity of the current coating, click Edit to modify the record
5)
Shut down, click the "Shut down" button to put the instrument into the shutdown state, long press
can make the screen restarted
3.5 System Setting
1
）
Changing the screen brightness
