2.
1.
10. ADJUSTING SPRING: Lock spring and attach a shifter to the Pin. Wind the shifter clockwise to apply tension.
Use the size chart to determine how many turns of tension are required.
Link to Spring Chart Tension
Below
.
refer to picture 1.
Do
NOT
let go of the shifter while tensioning as the spring has a lot of force in it. Do
NOT
try and over tension the spring. When the right amount of tension has been applied, drop the holding tab
down and wind the spring back until it engages the pin
11. Install blind into brackets
NB: Spring end/lock off pin should be on the left side.
12. Fix hooks/bungee button to bottom fixing point with screws
NB: This measurement must be the same as saddles/bungee cords from
step 9
-
refer to picture 2
13.
Pull blind down and slip over hooks or bungee buttons.
Spring Tension Chart
https://www.betta-blinds.com.au/downloads/installation_guides/Spring%20Pretensioning%20Chart.pdf
Caution: Like all outdoor blinds, it is prudent to retract the blind in the presence of strong winds.
