Lower 5000KV for new Beta85X 4S, which could support 4S power which won't cause the issue of
overheat or burn (maybe the ESC). Also change motor cables from 30AWG to 28AWG.
Last Version: 1105 6000KV motors with 30AWG cables. In 4S power status, the motor will be overheat
and damaged. Which may cause the burnt on the ESC.
4 Flight guide
Always use caution when flying and operate in an open and controllable area. Please learn the flight
controls first before powering on the aircraft to fly.
4.1
FLY
Beginner Tipas
1.Start flying Line of Sight(LOS)first to familiarize yourself to the controls.
2. When flying BETAFPV,don't try to hover still.Instead,keep flying in a forward direction using Yaw to look
around and change direction.This will ensure you are aware of your surroundings.
3. Land your BETAFPV when you see your voltage drop to 3.4 volts.Any lower and you may experience
Brown Out and also damage your Lipo Battery.Brown Out is when the craft stalls due to lack of power.
Flight preparation
1. Power on BETAFPV by sliding the battery into the battery tray and plugging it in.
2. Then by powering on your BETAFPV,and bind to your radio and the channel that matches your goggles
3. Once the battery is plugged in, set BETAFPV on a stable surface so it can calibrate. Calibration takes a
few seconds then BETAFPV is ready to fly. BETAFPV can fly for 4 minutes on a fully charged battery.
Land BETAFPV when the battery is low; flying any longer can severely damage your battery and is not
recommended.
4. After completing the above steps, you can start flying your micro whoop quadcopter.
