Beta Max MAXIAL TRACK HOIST, Use And Maintenance Instruction Manual

Page: 27 / 160

Use and Maintenance Instruction Manual
MAXIAL TRACK HOIST
REV. 2.2 (2017)
MACHINE INFORMATION
Page | 3-4
Figure 3.3
Figure 3.4
Figure 3.5
3.3.1 Track components
3.3.1.1 Base Feet
The Base Feet are an important component in
stabilizing the base of the ladder track. The Base Feet
create a larger footprint for the ladder track rails.
Stabilty is dependent on the machine’s footprint.
3.3.1.2 Kwik Bolts
Kiwk Bolts are used to attach the base feet and other
ladder track sections together. They are designed to
not come apart so that it can be easily installed and
tightened without the possibility of dropping the
individual components. The openings allowed for Kwik
Bolts are longer on one side than the other, this allows
the Kwik bolt to be placed in the hole and then twisted
90 degrees. Once twisted 90 degrees the Kwik Bolt can
be held in place and the wing nut tightened without the
use of additional tools.
3.3.1.3 Scaff-Clamps
Scaff-clamps are used to attach and secure the ladder
track sections to a scaffold structure. They are of a u-
shape design with cutout notches and a threaded T-
bolt. The u-shaped Scaff-clamp slips over a scaffold
hortizontal member, the notches then grab the inside
rail of ladder track, once in place tightening of the T-
bolt pulls the ladder track against the scaffold
hortizontal member. Two Scaff-clamps are to be
installed at each attachment location and should be
spaced no further than 6 ft. 6 in. apart.