6
Bestway
®
If you do not adhere to the maintenance guidelines below, your health might be at risk, especially that of your children.
NOTE:
The filter pump is used to circulate the water and to filter small particles to keep your water free of suspended dirt particles. In order to keep
your pool water clean and hygienic you must add chemicals.
To keep your pool clean:
1. Contact your local pool supply shop for advice and purchase of chemicals and PH kits.
2. Locate a bucket of water next to pool to clean users’ feet before entering pool.
3. Cover the pool when not in use.
ATTENTION: THE BESTWAY POOL COVER IS NOT A SAFETY COVER.
4. Skim pool regularly to avoid settled dirt.
5. Change filter cartridge in filter pump every 2 weeks.
6. Gently clean any scum from the side with a clean cloth.
Proper maintenance can maximize the life of your pool.
ATTENTION:
Ensure you run your filtration system everyday for 7-8 hours, but no more than 8 hours as overheating and damage to your pump may
occur. Do not use pump when pool is in use.
If your pool is damaged, use a repair patch. -see FAQ’s for instructions.
Filling Pool with Water
Pool Maintenance
Repair
Connection Valve Assembly
For 549cm x 122cm (18’ x 48”) and 549cm x 132cm (18’ x 52”) pool model
1. Screw the Debris Screen onto the Connector. (See Fig.12)
2. From inside the pool, insert this assembled Unit to the pool’s inlet A and outlet B. (See Fig.13)
NOTE:
Ensure the Gasket is properly in place on the assembled Unit inside of the pool liner.
3. From outside of the pool, tighten the Connector Nut onto the assembled Unit by the Wrench. (See Fig.14)
4. Hand-tighten the Control Valve to the assembled Unit. (See Fig.15)
NOTE:
Check that both the Control Valve Gasket and O-ring are correctly positioned on the Control Valve.
5. Refer to the pool manual for the rest of the pool installation.
OPERATION NOTE:
Use the control screw on top of the Control Valve to open and close the Valve. (See Fig.16)
6. Make sure the valve is closed.
ATTENTION:
Do not leave pool unattended while filling with water
1. Fill pool to drain valve.
STOP
2. Turn water off. Check that the water is not collecting on any side to ensure the pool is level. If pool is not level, drain water and re-level ground by
digging out (See Fig. 19). Never attempt to move the pool with water in it, serious personal injury or damage to the pool may result.
NOTE:
Your pool may contain up to xxxxx liters / xxxx gallons which equals xxxxx pounds of pressure. If your pool has any bulge or uneven side
then the pool is not level, the sides may burst and the water may discharge suddenly causing serious personal injury and/or damage to property.
3. When level, fill pool to lowest pump valve.
STOP
4. Turn water off. Check valves for secure fit.
5. Fill pool until water capacity is 90%, DO NOT OVERFILL as this could cause the pool to collapse. In times of heavy rainfall you may need to empty
some of the water to ensure the level is correct. (See Fig. 18)
6. Check pool for any leaks at valves or seams, check ground cloth for any evident water loss. Do not add chemicals until this has been done.
7. In the event of a leak, patch your pool using the patch kit provided. Refer to the FAQ’s for further information.
Fig. 18
Fig. 19
Proper Water Level
Flat, Level Ground -
CORRECT
Bumpy, Sloping Ground -
INCORRECT
Fig. 17
Gasket
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 12
Pool Outside
Pool Outside
Pool Outside
Gasket
Fig. 11
ჼྠᆭࡖඪԄ ϸ
S-S-000688
