BestCode Next 8 Series, Technical Manual, Page: 27 / 305

BestCode Next Series 8 Technical Manual October 2022 Page 13 of 290
Printhead Mounting
This section is intended to discuss Printhead mounting methods.
Printhead Mounting Safety
WARNING
PERSONAL INJURY & EQUIPMENT DAMAGE:
The resistance between equipment Cabinet or Printhead
and the factory earth ground should measure between 0 and 1 ohm. If that value is greater than 1
ohm, a dedicated earth ground may be required. This test should be regularly performed to ensure the
quality and reliability of the electronic circuitry.
WARNING
EQUIPMENT DAMAGE: Never use the multimeter to measure resistance while the printer is powered
on. This is a short circuit and may damage the electronics and the multimeter.
Do use multimeter to attempt to measure the charge voltage at the printhead. This will permanently
damage the main board.
WARNING
PERSONAL INJURY & EQUIPMENT DAMAGE:
Most Inks and Makeups are highly flammable liquid.
Dried ink can also be highly flammable, so great care should be taken to avoid exposing the fluid to
heat, sparks, static, and any other potential source of spark.
Inks and Makeups are potentially hazardous substances. Always read the SDS of the Ink, Makeup, and
Cleaner before operating, servicing, or performing maintenance on the Printer. Always wear proper
protective equipment when handling Ink, Makeup, or Cleaner. Wear solvent resistant gloves (Nitrile)
and safety glasses to prevent accidental exposure. Never use cleaner to wash Ink or Makeup stains
from skin, hair, or nails.
BESTCODE SAFETY DATA SHEETS:
https://support.bestcode.co/safety-data-sheets/
WARNING
EQUIPMENT DAMAGE:
The printhead should never be submerged in Cleaner. This can cause
un-repairable damage to the printhead.
The printhead must be dry before starting the Printer.