85183-3 AN
22
SERVICE: 1-888 8BESTAR (1-888 823-7827)
1
Determine the position of the bed in the room.
3
Locate and mark the positioning
of 2 studs using a stud finder.
5
Line up back panel #80 on the wall and mark the middle of the studs on the back panel, then pre-drill
part #71 with 1 pilot hole of 1/8 in (3 mm) diameter per stud (2 holes in total).
DO NOT DRILL HOLES INTO THE WOOD STUDS.
2
Move the bed if necessary, then remove
the floor trim completely.
4
Put the bed back in its place. Level by adjusting
the legs PA-844 previously installed. If you install
the bed on a carpet, you must raise the bed by
an extra 3/8 in (10 mm).
80
80
1/8 in (3 mm)
1/8 in
(3 mm)
80
PA-844
WALL ANCHORING INSTRUCTIONS
WOOD STUDS
INSTALLATION RECOMMENDATIONS
