4
1
Determine and mark the position
of the bed in the room.
Pre-drill the back panel #71 with 2 pilot holes of 1/8 in (3 mm) diameter, one on the left and one on the right.
With the bed in position, mark the position of the 2 holes on the masonry wall.
3
Put the bed back in its place. Level by adjusting
the legs PA-844 previously installed. If you install
the bed on a carpet, you must raise the bed by
an extra 3/8 in (10 mm).
2
Move the bed if necessary, then remove
the floor trim completely.
1/8 in
(3 mm)
71
71
1/8 in
(3 mm)
Locate and mark
the positioning
of the 2 anchor
points.
71
PA-844
70183-3 AN
20
SERVICE: 1-888 8BESTAR (1-888 823-7827)
WALL ANCHORING INSTRUCTIONS
INSTALLATION RECOMMENDATIONS — MASONRY
