4
1
WALL ANCHORING INSTRUCTIONS
INSTALLATION RECOMMENDATIONS — MASONRY
Determine and mark the position
of the bed in the room.
87
Pre-drill the piece of plywood #87 with 6 pilot holes of 1/8 in (3 mm) diameter distributed horizontally in order to cover
the width of the anchoring section. With the bed in position, mark the position of the 6 holes on the masonry wall.
87
1/8 in
(3 mm)
87
1/8 in (3 mm)
Locate and mark
the positioning
of the 6 anchor
points.
3
Put the bed back in its place. Level by adjusting
the legs PA-844 previously installed. If you install
the bed on a carpet, you must raise the bed by
an extra 3/8 in (10 mm).
PA-844
2
Move the bed if necessary, then remove
the floor trim completely.
85182-2 AN
27
SERVICE: 1-888 8BESTAR (1-888 823-7827)
