BEST ACCESS SYSTEMS 34HW, Service Manual, Page: 153 / 228

Additional Service and Maintenance for IDH Max Locks
W Series Service Manual 6–13
Removing and
reinstalling the
magnetic stripe
insertion card
reader
Removing the magnetic stripe insertion card reader
1. Remove the core and throw member. For mortise instructions, see
Task A. To remove the core: on page 4–3 . For cylindrical
instructions, see Task A. To remove the core and throw member:
on page 5–3 .
2. Remove the inside and outside knobs/levers. For mortise
instructions, see Task B. To remove the inside and outside
levers/knobs:
on page 4–4 . For cylindrical instructions,
see Task B1. To remove the keyed lever/knob: on page 5–3 .
3. Use the appropriate bit driver to remove the security screw from the
access door. Open the access door and remove it from the inside
escutcheon.
4. Remove the outside escutcheon. For mortise instructions, see Task
D. To disconnect the connections and remove the outside
escutcheon:
on page 4–6 . For cylindrical instructions, see Task D.
To disconnect the connections and remove the outside escutcheon:
on page 5–4 .
5. Unscrew the two reader electronics screws on the card reader and
remove the harness clamp. Save the harness clamp and screws.
6. Disconnect the reader wire harness from the circuit board on the
card reader.
7. Remove the card reader.
Figure 6.5 Removing and reinstalling the magnetic stripe swipe card reader
Reader harness
Magnetic stripe
swipe card
reader assembly
Outside escutcheon
Slot
Reader gasket