BEST ACCESS SYSTEMS 34HW, Service Manual, Page: 137 / 228

Service and Maintenance for Cylindrical Locks
W Series Service Manual 5–27
3. Remove the through-bolts and the RQE rose liner.
Reinstalling the RQE rose liner
1. Place the RQE rose liner on the chassis, aligning the holes in the
rose liner with the holes prepared in the door.
Caution
Make sure that there is clearance for the solenoid wire between
the RQE rose liner and the door.
2. Install the through-bolts through the RQE rose liner and door in the
top and bottom holes.
3. Tighten the RQE rose liner on the door with the through-bolts.
4. Connect the RQE connector.
5. For IDH Max Locks
■
Reinstall the inside hub washer.
■
Reinstall the upper and lower escutcheon screws on the inside
escutcheon.
■
Reinstall the inside lever/knob. See
Task H. To reinstall the inside
and outside levers/knobs: on page 5–16 .
■
Reinstall the access door. See Task J. To reinstall the access door:
on page 5–18 .
Figure 5.32 Removing and reinstalling the RQE rose liner (IDH Max shown)
RQE rose liner
Through-bolt
RQE wire
Solenoid wire
Inside of door
RQE rose liner
Hub washer