BD930000
- IPR-K
Programming manual
v1.0
www.besknx.com
8
6
Line Coupler parameters
Parameterization of the device is done from the ETS. The description of each parameter is shown in this chapter.
6.1.1
General
Nombre
Manual function
Valores
Disabled / Pass all telegrams / Pass all Physical telegrams / Pass all Group telegrams
Descripción Configuration setting for telegram routing when the Manual Function is active.
Nombre
Switch-off time for Manual Function
Valores
10 min / 1 hour / 4 hours / 8 hours
Descripción After expiry of this time period the Manual Function is switched off automatically.
6.1.2
Main line
For Group Telegrams and Physical Telegrams the setting “transmit all” is intended only for testing purposes. Please do not
use for normal operation.
Name
Telegram routing
Values
Group: filter, Physical: block / Group and Physical: filter / Group: route, Physical: filter /
Group and Physical: route configure
Description
-
Block: No telegrams are routed.
-
Filter: telegrams entered in the filter table are routed.
-
Route: all telegrams are routed
-
Configure: the following parameters must be set manually.
Name
Group telegrams: Main group 0…13
Values
Transmit all (not recommended) / Block / Filter
Description
-
Transmit all:
Group telegrams (main group 0…13) are all routed.
-
Block:
Group telegrams (main group 0…13) are all blocked.
-
Filter:
Group telegrams (main group 0…13) are routed if entered in the filter table
Name
Group telegrams: Main group 14…31
Values
Transmit all (not recommended) / Block / Filter
Description
-
Transmit all:
Group telegrams (main group 14…31) are all routed.
-
Block:
Group telegrams (main group 14…31) are all blocked.
-
Filter:
Group telegrams (main group 14…31) are routed if entered in the filter table
Name
Physical telegrams
Values
Transmit all (not recommended) / Block / Filter