BERTHOLD TECHNOLOGIES LB 480, User Manual

Page: 289 / 450

SENSseries LB 480 Level measurement
BERTHOLD TECHNOLOGIES GmbH & Co. KG
2 – 289
Volume 2 6 Accessories
2
6
Accessories
6.1
Cable glands
The sealing of the screwed fittings on the cable can be made of sev-
eral sealing rings, depending on the screwed fitting, which have to
be adapted to the diameter of the cable. The sealing rings inserted
into the screwed fittings allow a relatively large cable clamping
area. Remove the sealing rings from the screwed fitting to adapt
them to the cable diameter used. A list of screwed fittings available
from BERTHOLD TECHNOLOGIES can be found in the manual for
explosion protection on
page 1-47 .
The following is an example for a M20 cable gland with additional
sealing ring for small cable diameters, that must be removed for
cables with larger diameter.
Assembly instructions for ID No. 55412 and 56086
blue globe ® – Montage
blue globe ® – Installation
Abb. 1
Fig. 1
blueglobe
®
mit kleinem Kabeldurchmesser
Bei IP 68 Installationen globemarker ® außenliegend
blueglobe ® with small cable diameter
With IP 68 installations globemarker ® on the outside
Abb. 2
Fig. 2
blueglobe ® mit kleinem Kabeldurchmesser
oder globemarker ® entfernen
blueglobe
®
with small cable diameter
or removing globemarker ®
Abb. 3
Fig. 3
blueglobe ® mit großem Kabeldurchmesser
Bei großem Kabeldurchmesser Inlet ent fernen: Schraubendreher
senkrecht in Trennnaht einstechen
blueglobe ® with large cable diameter
With a large cable diameter – remove inlet. Insert screwdriver
vertically into separating seam
Abb. 4
Fig. 4
blueglobe ® mit großem Kabeldurchmesser
Inlet aushebeln
blueglobe ® with large cable diameter
Lift out the inlet