Embroidery
141
2022-08 EN 5020079.40A.04
15 Embroidery
15.1 Embroidering via the Button «Start/Stop»
In case of a power cut the embroidery process is interrupted. After the restart the machine goes to the
position which was embroidered last.
> Push the button «Start/Stop» until the embroidery machine starts.
– All parts of the design being in the current color are embroidered.
– The embroidery machine stops automatically at the end.
– Both threads are cut automatically.
– The embroidery machine switches to the next color automatically.
> Change the upper thread.
> To embroider the new color, push the button «Start/Stop».
–
After having completed the embroidery design, the machine stops automatically and the threads are
cut automatically.
> To end the embroidery design, tap «Confirm» (1).
1
1
15.2 Adjusting the Upper Thread Tension
The default setting of the upper thread tension is set automatically as soon as a embroidery design is
selected.
When using different types of embroidery threads, the upper thread tension may vary. It may therefore be
necessary to adjust the upper thread tension individually according to the embroidery project as well as the
desried stitch.
The higher the upper thread tension is set, the tighter the upper thread is tensioned, and the bobbin thread
is pulled deeper into the fabric. When the upper thread tension is low, the upper thread is less tightened,
and the bobbin thread is pulled up less into the fabric.
Alteration of the upper thread tension affect the currently embroidery design. Permanent alterations of the
upper thread tension can be made in the Setup Program.
4.00
> Tap «Upper Thread Tension».
