Creative embroidering
66
2022-08 EN 5020070.40A.04
Embroidery Sequence Control when the Thread Breaks
If the thread breaks, the needle can be repositioned in the embroidery design using the function Embroidery
Sequence Control.
> Select the embroidery design.
> Tap «Embroidery».
> Tap «Embroidery Sequence Control».
– A compact view of the embroidery design appears on the left side of the display. On the right side the
embroidery design is shown in enlarged view.
–
Repositioning via Compact View
> Select the desired position in the overall view (1) (2).
–
Repositioning via Stitch Bar
> Select the bar in the display (3) (4).
–
Repositioning via Multi-function Knobs
> To move the embroidery hoop stitch by stitch, turn the «Upper Multi-function Knob».
> To move the embroidery hoop in large steps, turn the «Lower Multi-function Knob».
–
Repositioning via Magnifier
> To select the desired stitch via the input, tap «Magnifier» (6).
1
2
5
6
3
4
– The number in the yellow-framed icon (5) indicates the number of stitches of the embroidery process.
> Set the needle position back so that the new start is made a few stitches before the thread has broken.
Cutting Connecting Stitches
The function is activated as standard and the connection stitches are automatically cut. If the function is
deactivated, the connection stitches must be cut by hand.
> Select the embroidery design.
> Tap «Embroidery».
> To switch off the function, tap «Cut Connecting Stitches».
> To switch on the function, tap «Cut Connecting Stitches» again.
Summary of Contents for b70 DECO
Page 1: ...User Manual...
Page 2: ......
