12
Winding the Bobbin
Pull the handwheel out.
Draw the thread from the spool.
Guide the thread around the bobbin winder pre-
tension.
Insert the thread through the hole in the bobbin
from the inside to the outside.
Put the bobbin on the bobbin winder spindle.
Push it to the right.
With the free end of the thread held in your hand,
depress the foot control.
Stop the machine when it has made a few turns,
and cut the thread close to the hole in the bobbin.
Depress the foot control again.
When the bobbin is fully wound, stop the machine.
Return the bobbin winder spindle to its original
position by moving the spindle to the left, and cut
the thread.
Push the handwheel back into the original position.
Threading the Bobbin Case
Place the bobbin into the bobbin case.
Make sure the thread unwinds in the direction of
arrow.
Pull the thread into the bobbin case slot.
Draw the thread under the tension spring and into
the delivery eye.
* Pull a thread roughly 4" (10 cm) long from the bobbin.
PLEASE NOTE:
When stopping the machine, push the bobbin
winder spindle to the left.
