23
E N G L I S H
Instructions for Use
WARNING:
Always observe the safety
instructions and applicable regulations.
PRIOR TO OPERATION:
•
Make sure your battery pack is (fully) charged.
OPERATION
WARNING:
Turn unit off and disconnect
battery pack before installing and removing
accessories, before adjusting or when making
repairs.
Proper Hand Position (fi g. D)
WARNING:
To reduce the risk of serious
personal injury,
ALWAYS
use proper hand
position as shown.
WARNING:
To reduce the risk of serious
personal injury,
ALWAYS
hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the pistol
grip (3).
Switching On and Off (fi g. A)
•
To run the tool, press the on/off switch (1).
–
To select forward rotation, press the lower part
of the switch.
–
To select reverse rotation, press the upper
part of the switch.
•
To stop the tool, release the switch.
WARNING:
Always wait until the motor has
come to a complete standstill before changing
the direction of rotation.
Screwdriving or Nutsetting (fi g. A)
•
Select the appropriate socket for the screw or nut
to be driven.
•
Select forward or reverse rotation as described
above.
•
Hold the tool in line with the fastener.
•
After tightening, check torque with a torque
wrench.
Tightening Time
This tool tightens most fasteners in few seconds. The
proper tightening time in relation to torque must be
determined by experience.
Use only dedicated impact accessories with your tool.
Consult your dealer for further information on the
appropriate accessories.
MAINTENANCE
Your Berner power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of serious
personal injury, turn tool off and
disconnect battery pack
before making
any adjustments or removing/ installing
attachments or accessories. An accidental
start-up can cause injury.
The charger is not serviceable. There are no
serviceable parts inside the charger.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING:
Blow dirt and dust out of the main
housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear
approved eye protection and approved dust
mask when performing this procedure.
WARNING:
Never use solvents or other harsh
chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the
materials used in these parts. Use a cloth
dampened only with water and mild soap.
Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING:
Shock hazard. Disconnect the
charger from the AC outlet before cleaning.
Dirt and grease may be removed from the
exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or any
cleaning solutions.
Optional Accessories
WARNING:
Since accessories, other than
those offered by Berner, have not been tested
with this product, use of such accessories
with this tool could be hazardous. To reduce
the risk of injury, only Berner, recommended
accessories should be used with this product.
