Bernecker + Rainer 5PC820.SX01-00, User Manual

Page: 132 / 318

132
Software • BIOS options
Automation PC 820 User's Manual V 1.20
1.5.9 IDE Configuration
Figure 52: 945GME Advanced IDE Configuration
BIOS setting Meaning Setting options Effect
ATA/IDE
Configuration Option for configuring the integrated
PATA and SATA controller. Compatible Both controllers run in Legacy or Compatible
Mode.
Disabled Both controllers disabled.
Enhanced Both controllers run in Enhanced or Native Mode.
Legacy IDE
Channels Option for configuring the Legacy IDE
channels in Compatible Mode. SATA Pri, PATA Sec SATA drives are address primarily and PATA
drive secondarily.
SATA only Only use SATA drives.
PATA only Only use PATA drives.
Primary IDE Master The drive in the system that is connected
to the IDE primary master port is
configured here. Enter Opens the submenu
See "Primary IDE Master", on page 134
Primary IDE slave The drive in the system that is connected
to the IDE primary slave port is configured
here. Enter Opens the submenu
See "Primary IDE slave", on page 136
Secondary IDE
Master The drive in the system that is connected
to the IDE secondary master port is
configured here. Enter Opens the submenu
See "Secondary IDE Master", on page 138
Table 89: 945GME Advanced IDE Configuration setting options
Advanced
IDE Configuration
Legacy IDE Channels [SATA Pri, PATA Sec]
Primary IDE Master : [ ]
Primary IDE Slave : [Not Detected]
Secondary IDE Master : [
Not Detected
Not Detected]
Secondary IDE Slave : [Not Detected]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host & Device] Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
ATA/IDE Configuration [Compatible]
BIOS SETUP UTILITY
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.