Switch/shutter actuator 8/4gang 16A RMD
75318003
Switch/shutter actuator 16/8gang 16A
RMD
75310002
Technical
Documentation
© Berker GmbH & Co KG 2007
Version: 04.04.2007
Part 5
(Subject to prior change)
75310002.doc
Seite: 171 / 174
Behaviour at the end of the
disabling function:
no change of switching
state
switching off
switching on
setting tracked state
blinking
The behaviour of the output at the end of the
disabling function can be parameterized.
At the end of disabling, the internal switching
state is not changed. Thereafter, the output is
again enabled.
At the end of disabling, the switching state is set
to off. The output is re-enabled.
At the end of disabling, the switching state is set
to on. The output is re-enabled.
At the end of disabling, the last switching state
existing before the disabling function or the
switching state internally tracked during the
disabling function will be set. - In this case,
residual times of time functions or of the
staircase functions will be tracked as well, if
they have not completely elapsed at the time of
re-enabling the disabling function.
At the end of disabling, the output blinks on and
off and is re-enabled. Blinking persists until a
new switching state is set. The blinking time is
generally parameterized for all outputs under
"General". During blinking, the logic switching
state is "ON - 1".
The states set at the end of the disabling
function do not start time functions.
Exception: "set tracked state").
If a logic operation is parameterized, the state
is evaluated in the logic operation function in
such a way as if the state had been updated
via the "Switching" object (no evaluations of
time functions).
This parameter is only visible, if the
parameter "Selection of supplementary
function is set to "disabling function".