Assembly & initial set-up
4
B.
Position the worm assembly (item 1) on the
frame of the snowblower in the location shown.
Secure in place with a hex bolt 3/8" n.c. x 1 1/4"
(item 2), two hex bolts 3/8" n.c. x 1" (item 3)
and nylon insert lock nuts (item 4).
Installation of the handle support
A.
Remove the two nuts (item A) from the lever
arm, insert the handle support (item 1) (in the
holes shown) on these bolts and reinstall the
nuts.
B.
Insert the plastic grommet (item 1) in the
adjustable support (item 2). Position the
adjustable support to the desired height
(adjustment may be necessary once the handle
is installed and the snowblower is installed on
the tractor) and secure in place with two hex
bolts 5/16" n.c. x 3/4" (item 3) and nylon insert
lock nuts (item 4).
C.
Insert the handle (item 1) on the handle (item
2). Hook the adjustable handle hook (item 3) to
the chute rotation worm. Insert the handle
(item 2) in the handle support and attach to the
handle hook (item 3). Secure in place in the
middle hole (an adjustment may be necessary
when the handle is installed and the
snowblower is installed on the tractor) with the
hair pin (item 4).
