10
OPERATION
SNOWBLOWER OPERATION
a) Make sure the snowblower is clear of snow
before engaging the snowblower.
b) Make sure that the auger and impeller operate
freely.
c) Start the tractor engine.
d) Before engaging the snowblower drive, always
have the engine running at medium R.P.M.
e) When removing snow, do not use the snowblower
as a dozer blade to push snow. Allow snowblower
to ingest snow at its own speed. If the speed of
your tractor is too fast, the snowblower may
become overloaded and plug.
IMPORTANT: USE FULL ENGINE R.P.M. WHEN
REMOVING WET OR STICKY SNOW. LOW R.P.M.
WILL TEND TO PLUG THE CHUTE.
WARNING
TO PREVENT INJURIES:
-Do not attempt to clear plugged chute, auger or
fan of snow while vehicle engine is running.
-Disengage attachment.
-Lower attachment onto ground.
-Set the parking brake.
-Stop engine, remove the ignition key, disconnect
the wire from spark plug(s) and keep away from
spark plug(s) to prevent accidental starting.
-Make sure all moving parts have stopped.
-Do not use hand to unplug chute.
-Use a 36’’ (924 mm.) minimum length stick or
board.
WARNING
Read the tractor Owner’s Manual carefully. Be
thoroughly familiar with the controls & proper
use of the attachment. Know how to stop the
attachment quickly
.
CONTROLS
CHUTE ROTATION
The chute rotation handle is located to the left of
steering wheel. Turning the handle in a clockwise
direction, the discharge chute will turn in a clockwise
direction or vice versa.
CHUTE DEFLECTOR
Set the angle of the deflector according to the distance
the snow must be thrown. To change the deflector
angle, loosen the two deflector knobs & adjust the
deflector to the appropriate angle.
WARNING
TO PREVENT INJURIES AND FOR MORE
TRACTION WHEN USING AN ATTACHMENT:
-Rear counterweight of 100 lbs. minimum is
required to counterbalance the attachment’s
weight.
-Manufacturer approved tire chains are required.
-Do not operate on a slope greater than 10°.
-When dismounting the attachment remove rear
counterweights.
-Ear muffs and safety glasses are recommended.
