Berbel BKF 90 iPP, Operating And Installation Instructions

Page: 149 / 164

149
Operation
6006113_a – 01.06.2022
EN
4.5.6 Automatic rapid heat-up function
Available in menu level 2 on all cooking zones.
Function to quickly heat the cooking zone to the selected
power level.
When activated, the selected cooking zone heats up with
maximum power for a certain time and then switches to the
desired power level.
☞ Press the slider at the position below the
symbol.
☞
Choose the desired cooking zone.
☞ Select the desired power level (e.g. power
level 5).
y
The “A” indicator and the selected power
level flash alternately.
y
After the end of the rapid heat-up time,
the cooking level switches to the desired
power level.
y
With selection of a lower power level, the
automatic rapid heat-up is switched off.
y
If no power level is selected, the cooking
zone changes back to menu level 1 after
3 seconds.
4.5.7 Simmer function
Available in menu level 2 on all cooking zones.
Function for simmering food at three levels.
☞
Press the slider at the position below the
symbol to select the simmering level.
y
The selected simmering level is displayed
on the 7-segment display.
y
The cooking zone is heated accordingly.
Lowest level
Medium level
Highest level
Off
4.5.8 Automatic pot recognition function
Available in menu level 3 on cooking zone 4 and if no
cooking zone is active (all power levels = 0).
Function for automatic recognition of cookware placed on a
cooking zone.
y
Upon detection, the 7-segment display for the cooking
zone in use lights up.
y
It is possible to operate the selected cooking zone directly
via the slider.
y
As delivered, the function is activated.
☞ Press the slider at the position below the
symbol.
y
The symbol illuminates dimly.
y
Automatic pot recognition is switched off.
To switch the function on again:
☞ Press the slider again at the position below
the symbol.
y
The symbol illuminates brightly.
If the “bridge” function is in use, the cookware may not be
automatically detected (e.g. because the size is insufficient or
the material does not optimally conduct).
D
“4.5.3 Bridge function” (page 148).
4.5.9 Beep function
Available in menu level 3 on cooking zone 4 and if no
cooking zone is active (all power levels = 0).
Function for setting the acoustic signal.
The acoustic signal can be set to the following
levels:
y
Loud - symbol illuminates brightly.
y
Medium - symbol illuminates brightly.
y
Quiet - symbol illuminates brightly.
y
Off - symbol illuminates dimly.
☞
Press the slider repeatedly at the position
below the symbol until the desired signal
is set.