Berbel BKF 90 iPP, Operating And Installation Instructions

Page: 139 / 164

139
Installation
6006113_a – 01.06.2022
EN
☞ Seal the cut surface of the work top with suitable material
(heat resistant to 75 °C – e.g. special paint, silicone rubber
or cast resin).
For the material used, the worktop manufacturer’s
instructions must be followed.
☞ Place the hob into the specified position in the lower
cabinet from above.
3.3.5 Establish electrical power supply
D
WARNING!
Risk of death due to electric shock!
Touching live parts can cause an electric shock, burns or
death.
☞ Ensure that the voltage supply is and remains
disconnected while the following work is in progress.
D ATTENTION!
Danger of property damage due to incorrect connection!
If the hob is connected with further devices (e.g. oven),
damage can arise due to overvoltage. The customer must
provide a separate connection point with dedicated fuse for
the hob.
☞ Make sure that the device is connected separately.
☞ Make sure the connection is separately protected with a
circuit breaker and a residual current device.
☞ Observe the voltage specifications on the ratings plate.
☞ Connect the device to the power supply provided by the
customer. The junction box is located on the underside of
the device.
Connection to spring-loaded terminals (e.g. in cooker
connection boxes) is not permitted.
Connection possibilities:
y
400 V ~ / 50/60 Hz – 2P+N
N L1 L2
4 5 1 2 3
Cable H 05 VV - F, H 05 RR - F,
Diameter 4 x 2.5 mm
2 ,
Fuse 16 A
y
230 V ~ / 50/60 Hz – 1P+N
(optional, not compatible with AutoRun module)
N L1
4 5 1 2 3
Cable H 05 VV - F, H 05 RR - F,
Diameter 3 x 4.0 mm
2 ,
Fuse 40 A
☞ Route the cables so that they are not kinked, crushed or
damaged and do not come into contact with hot parts of
the device.
☞ Make sure that the device can be disconnected on all
poles from the electricity supply after installation.
After switching on the power supply, the device is ready for
operation.
3.3.6 Check and carry out commissioning
D
ATTENTION!
Risk of disruptions due to moisture in the device!
If the device is moved from a cold environment into a hot
one, condensation may form inside.
☞
Wait about 2-3 hours before bringing the device into
service.
☞
Ensure that the device is accessible for maintenance work
at all times.
☞
Check that an all-pole isolating device (min. 3 mm contact
gap) is present.
☞
Check that the mains cable and the electrical connection
cable are not kinked, crushed or damaged.
☞
Make sure that the protective film is removed.
☞
Check the correct functioning of the device.
D
“4. Operation” (page 140).