Berbel BIH 100 GL, Operating And Installation Instructions

Page: 24 / 36

24
Operation
6005735_0 – 31.03.2021
4.2.2 Extraction mode / recirculated air mode
changeover
If the device is configured for hybrid mode, it is possible to
switch between extraction mode and recirculated air mode
at any time after activating the changeover function.
The changeover function is activated in configuration mode.
D “4.3 Configuring the device” (page 26).
Button Function
If the changeover function is activated:
☞
Touch the button one time.
Button glows dimly:
y
The device operates in extraction mode.
y
The wall box is opened.
y
The cleaned air is discharged outdoors.
Button glows brightly:
y
The device is operating in recirculated air
mode.
y
The wall box is closed.
y
The cleaned air is discharged into the
room.
4.2.3 Filter filling indicator
The device has a check indicator in order to remind the
operator to change the filter filling. If no recirculated air filter
is used, the control indicator does not have any meaning.
The function is set so that the button flashes every 1,000 fan
operating hours (flash duration 120 seconds) as soon as
the device is turned off. The hours counter is restarted by
switching off the control indicator.
Button Function
Button flashes:
The filter filling must be replaced.
D
“6.2.2 Replacing filter filling (with
recirculating and hybrid mode)”
(page 29).
☞
Hold the button (> 1 second) to restart the
hours counter.
4.2.4 Window contact switch
If a window contact switch is connected to the device, this
monitors whether the corresponding window is open or
closed. Extraction only takes place with
an open window or in recirculated air mode.
Button Function
Button flashes:
y
A window contact switch is connected to
the device.
y
The window is closed.
y
The device does not perform extraction.
☞
Open the window.
y
Extraction can be used.
4.2.5 Hob lighting
The hob lighting is dimmable and is equipped with energy-
saving LEDs. The lighting can be used independently of the
fan.
It can be switched on when the device is on. It can be
switched off at any time.
The colour temperature can be changed.
Button Function
Dimmer.
☞
Press the button once to switch the hob
lighting on or off.
☞
Hold the button (more than 1 second)
to start the dimmer. After releasing the
button, the hob lighting remains at the
selected brightness.
After switching off, the hob lighting starts with
full brightness the next time it is switched on.
Colour temperature.
☞
Touch the button one time.
☞
Touch and hold the button again within
half a second to start the colour cycle.
The hob lighting switches on, the colour cycle
starts.
☞
Release the button when the desired
colour temperature is reached.
The colour cycle stops, and the selected
colour temperature is saved.