600V/1000V DC Combiner Installation and Operating Instructions – 36-String Disconnect Models
950-002305-000 Rev A
28
Chapter 3: Installation Procedure
CAUTION
CAUTION
Follow installation instructions from the fittings manufacturer to assure
water-tight connections on upward-facing areas of the enclosure.
ATTENTION
Suivre
les
instructions
d'installation
du
fabricant
de
garnitures
d'assurer
les
raccordements
imperméables
à
l'eau
sur
des
secteurs
de
vers
le
haut
‐
revêtement
de
la
clôture.
Be sure to clean up any spatter immediately. If it is not cleaned up, it may cause
rust in the enclosure. If rusting occurs, use a rust remover and then apply
touch-up paint to prevent further rusting.
Cutouts for Steel Enclosures
This section provides drawings for cut-out areas for the steel enclosures. The
measurements for those areas are provided in
.
Figure 13
Area for cutouts when connecting wires through the bottom of a
combiner in a steel enclosure
Cutout area
