600V/1000V DC Combiner Installation and Operating Instructions – 36-String Disconnect Models
950-002305-000 Rev A
17
Chapter 3
Installation Procedure
This chapter describes the mounting and wiring or connections required to
install the Combiner.
Contact Bentek Support at 1-888-202-5009 for additional assistance.
Required Tools and Materials
Standard construction, electrical tools, basic electrical safety, and testing
instruments are required for the installation of the Combiner enclosure.
Additionally, the installation requires:
Calibrated torque wrench.
Personal protective equipment such as job-related clothing, electrical safety
gloves, safety goggles, etc.
Installers must reference the specific site scope and project drawings, including
the system layout and related electrical drawings, for additional information and
considerations.
CAUTION
CAUTION
The installer is responsible for verifying placement of internal components prior
to drilling holes and making any cutouts in the chassis.
ATTENTION
L'installateur est responsable de vérifier le placement des composants internes
avant les trous drilling et de faire tous les coupes-circuit dans le châssis.
