Multiple Disconnect Safety System Installation and Operating Instructions
950-001568-000 Rev A
17
Chapter 3
Installation Procedure
This chapter describes the mounting and wiring or connections required to
install the MDSS.
Prior to mounting and wiring the MDSS, remove any shipping supports or
materials.
Contact Bentek Support at 1-888-202-5009 for additional assistance.
Required Tools and Materials
Standard construction, electrical tools, and basic electrical safety and testing
instruments are required for the installation of the MDSS enclosure. Additionally,
the installation requires:
Calibrated torque wrench.
Personal protective equipment such as electrical safety gloves, safety
goggles, etc.
Installers must reference the specific site scope and project drawings, including
the system layout and related electrical drawings, for additional information and
considerations.
CAUTION
CAUTION
The installer is responsible for verifying placement of internal assemblies prior to
drilling holes and making any cutouts in the chassis.
