Alignment Instructions
21
We recommend the number of highlights on each mask as the following
table:
Adjust the height of the laser curtain depending the difference installation
environment.
PointWrite Calibration
PointWrite provides two kinds of calibration methods: auto calibration and
manual calibration.
Auto calibration: Click on
and the calibration process will run
automatically.
When you choose this method, white image is shown on the screen and the
pattern image is displayed.
Manual calibration: Click on
and calibration window will be
projected on the screen.
Use the PointWrite pen to click on the center of calibration cursor
immediately after it appears. Then the next cursor will display. Repeat this
process until the last calibration cursor disappears.
Caution: In rare circumstances, auto calibration may fail or accuracy may be
low. In this case, please execute the manual calibration.
Attached Position
Suggested Reflected Points
on the Mask
Mask 1, 2
Upper side of the screen
3 points
Mask 3, 4
Bottom side of the screen
3 points
