Operation
26
Operation
Starting up the projector
1.
Plug the power cord into the projector and
into a power outlet. Turn on the power
outlet switch (where fitted). Check that the
POWER indicator light
on the projector
lights orange after power has been applied.
• Please use the original accessories (e.g.
power cable) only with the device to
avoid possible dangers such as electric shock and fire.
• If Direct Power On function is activated in the SYSTEM SETUP: Basic
> Operation Settings menu, the projector will turn on automatically
after the power cord has been connected and power has been applied.
See
for details.
• If Signal Power On function is activated in the SYSTEM SETUP: Basic >
Operation Settings menu, the projector will turn on automatically
when VGA signal is detected. See
for
details.
2.
Press
POWER
on the projector or
ON on the
remote control to start the
projector. The
POWER
flashes and stays
orange when the projector is on.
The start up procedure takes about 30
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to adjust
the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan
for approximately 90 seconds before energizing the lamp.
I
I
