21
Operation
4. If you are prompted for a password, press the arrow keys to enter a 6-digit password. See
the password function on page 25
.
5. Switch all of the connected equipment on.
The projector will search for input signals. The current input signal being scanned appears. If the
projector does not detect a valid signal, the message “No Signal” will continue displaying until an input
signal is found.
You can also press
to select your desired input signal. See
Switching input signal on page 26
.
Setting up the QS01 HDMI Media Streaming
Before you start
Check that you have:
• A Wi-Fi Internet connection
• A Google Account
Reminder for installing QS01 HDMI Media Streaming
This message is displayed when the QS01 is not
detected. See
Installing the QS01 HDMI Media
for how to install the dongle.
• Please use the original accessories (e.g. power cord) to avoid possible dangers such as electric shock and fire.
• If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before
energizing the lamp.
• The Setup Wizard screenshots are for reference only and may differ from the actual design.
• If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message
“Out of Range”
displayed on the background screen. Please change to an input signal which is compatible with
the projector's resolution or set the input signal to a lower setting. See
.
• If no signal is detected for 3 minutes, the projector automatically enters saving mode.
• If “Reset All Settings” is selected, setup wizard will appear after reboot, and Auto Source will be reset to default
value.
