1.1 General notes
Introduction
5186 / 07/2021 en
BENNING CC 4-1 / CC 4-2
6
1
Introduction
The BENNING CC 4‑1 / CC 4‑2 current clamp adapter described here (in the following only
referred to as “device”) is a measuring adapter for multimeters. The device enables you to
perform AC measurements up to 1 000 A‑AC by means of a multimeter. The BENNING CC 4‑1
current clamp adapter additionally enables you to precisely measure low currents in the
mA range.
In combination with the BENNING IT 200 installation tester, the BENNING CC 4‑1 / CC 4‑2
current clamp adapter allows further measuring applications, e. g. earth resistance
measurement (earth loop resistance measurement) without using rods, power measurement,
current measurement and harmonic measurement.
Further information
http://tms.benning.de/cc4-1-cc4-2
On the Internet, you will find the following additional information directly at the specified link or
at www.benning.de (product search):
• Operating manual of the device in several languages
• Further information depending on the device (e. g. brochures, technical reports, FAQs)
1.1
General notes
Target group
This operating manual is intended for the following groups of people:
• Qualified electricians and electrotechnically trained personnel
Required basic knowledge
To understand these operating manual, you will need general knowledge of testing and
measuring equipment. Moreover, you will need basic knowledge of the following issues:
• General electrical engineering
Purpose of the operating manual
This operating manual describes the device and provide you information about how to handle it.
Keep this operating manual in a safe place for later use. Read this operating manual before
handling the device and follow the instructions.
NOTE
Disclaimer of liability
Please make sure that any person using the device has read and understood the instructions of
this operating manual before handling the device and that the instructions are adhered to in all
points. Non-observance of this operating manual might result in product damage, property
damage and/or personal injury.
Benning assumes no liability for damage and malfunctions resulting from the failure to observe
the instructions in this operating manual.