Bennett HIGH FLOW H35, Instruction Manual

Page: 8 / 98

Important Safety Instructions
Bennett HF H35 Instruction Manual 4
!! READ AND UNDERSTAND ALL WARNING LABELS ATTACHED TO THE DISPENSER !!
GENERAL INFORMATION
CAUTION: THE BENNETT HYDROGEN DISPENSER IS INTENDED FOR USE WITH FUEL CELL GRADE HYDROGEN AS DEFINED IN
COMMODITY SPECIFICATION FOR HYDROGEN, CGA G-5.3, AND WITH GAS COMPOSITION AT THE AT THE DISPENSER NOZZLE
AS SPECIFIED BY THE HYDROGEN FUEL QUALITY FOR FUEL CELL VEHICLES, SAE 2719, UNLESS ADDITIONAL PRECAUTIONS ARE
TAKEN.
Read this manual carefully and read all tags/labels attached to the Hydrogen dispenser or pump before starting any installation, operation,
maintenance, and/or service. A dispenser or pump that is not properly installed and/or maintained per our instruction will not perform
properly and will void the Bennett Limited Warranty.
Before installation, operation, maintenance and/or service ensure that protection against lighting strikes is in accordance with the American
Petroleum Institute Recommended Practice RP 2003,
Protection Against Ignitions Arising out of Static, Lightening, and Stray Currents .
Service of the Bennett products and all accessories must be performed by a technician who is trained in accordance with all codes,
standards, and regulations.
HAZARDOUS LOCATIONS
Classified areas are used to describe the fire or explosion hazards present in a specific area. For safe operation, ensure that the dispenser
is in a classified area as detailed below per NFPA 2,
Hydrogen Technologies Code and NFPA 70, National Electric Code .
CODES AND STANDARDS
A number of key standards applicable to this product are listed below. Note: This is not a comprehensive list. Always follow all applicable
local, state, and federal requirements for installation of all equipment.
•
API 2003 – Protection Against Ignitions Arising Out of Static, Lightning, and Stray Currents
•
ASME B31.12-2014 – Hydrogen Piping and Pipelines
•
NFPA 2 – Hydrogen Technologies Code
•
NFPA 50A – Standard for Gaseous Hydrogen Systems at Consumer Sites
•
NFPA 70 – National Electric Code
•
NFPA 496 – Purged and Pressurized Enclosures for Electrical Equipment
•
CSA/ANSI HGV 4.0 - CSA 12.5-18, HGV Dispensing Systems.
•
CSA/ANSI HGV 4.1 – Hydrogen Dispensing Systems
•
CSA/ANSI HGV 4.3 – Test Methods for Hydrogen Fueling Parameter Evaluation
•
CSA/ANSI HGV 4.9 - Hydrogen Fueling Stations
•
International Fire Code – 2000 Edition
•
SAE J2719-2015 – Hydrogen Fuel Quality for Fuel Cell Vehicles
UNAUTHORIZED ALTERATION OF BENNETT PRODUCTS
DANGER: BEFORE PERFORMING ANY TYPE OF SERVICE TO THE DISPENSERS, BE SURE TO SHUT OFF ALL ELECTRICAL SUPPLIES
AND SECURE THEM IN THE OFF POSITION. CLOSE ALL VALVES IN INCOMING PIPING. MAINTENANCE MUST BE
PERFORMED BY TRAINED PERSONAL ONLY.
Bennett Pump Company products are designed to meet or exceed the standards of Underwriters Laboratories, Inc., Federal Communication
commission, and National Institute of Standards and Technology. Compliance with these standards protects the operator and the consumer
from personal injury and ensure an accurate delivery of product. Any deviation from the use of authorized replacement parts or alteration
of a designed product configuration may cause personal injury, death, or the revocation of one or all of the above approvals.
Bennett Pump Company will not assume responsibility or liability for any consequential injury or damage caused by the unauthorized
alteration of its products.