Programming
Bennett HF H35 Instruction Manual
62
MENU CODE 66
–
NOZZLE TIMEOUT
Menu Code 66 allows the manager or operator to set the number of seconds that the dispenser will display “Fill Completed”
before signaling the customer to replace the nozzle.
PROGRAMMING PROCEDURE
1.
Press the number
6
and
6
, then the [
MODE
]
button on the keypad.
2.
Default is set to disabled. To change from disabled, press the numeric
buttons on the keypad to enter the number of seconds desired for the
time delay. Once the timer is activated, the user can disable the timer
by selecting the up arrow on the keypad.
Note
: The delay may be set
from 0 to 999 seconds.
3.
Press the [
ENTER]
button to save the new setting.
Note:
If an error is
made, press the correct number. The new number will replace the error.
4.
Press the [
CANCEL
] button to exit this Menu Code.
Figure 4.57
–
Nozzle Timeout
MENU CODE 94
–
WEIGHTS AND MEASURES TIMEOUT DELAY
Menu Code 94 allows the manager or operator to set the number of seconds that the dispenser will remain armed if the customer
replaces the nozzle after the READY state has been entered.
Note:
Weights and Measures regulations require that a dispenser
authorized for a credit sale must disarm itself 15 seconds after the handle has been replaced prior to the delivery of product. If
this timeout delay is ever set to any value other than 15 seconds, the customer should be made aware that the dispenser will no
longer meet Weights and Measures regulations.
Sale $
N O z z l E
Kilograms
5
C O d E
6 6
Summary of Contents for HIGH FLOW H35
