Benezan Electronics Installation Guide for Beamicon2Basic
Hardware and software development and
the MDLCNC-T4V6 driver
Nicolas Benezan, Stauffenbergstr. 26, 72108 Rottenburg
Phone:
+49
(0)
7457/946365
0
benezan-
electronics.de
Page
9
Beamicon2Basic_Manual_Letmathe_Englisch
(Vereinigte Staaten).docx
02.10.2020
Connecting the Micropod
The micropod is the heart of the controller. It contains a powerful 32bit microcomputer with 8
cores. This takes over the calculation of the steps and ramps and evaluates the reference
switches and 3D probes. The connection to the PC is made via an Ethernet cable.The
micropod requires 5V operating voltage. These can be removed from the connector of the FI
module.
Safety Instructions
The interface module may only be installed and put into operation by
qualified personnel. Please read the operating instructions carefully and
follow all instructions exactly. Improper installation or operation of the
device can cause damage to the electronics or the machine and can
result in dangers to the health of the operating personnel.
Depending on the hazard potential of the machine, additional safety
measures may be required, such as door interlocks and standstill monitoring. As a rule, such
safety functions must be implemented purely electromechanically with external circuits (not
included in the scope of delivery) and must not depend solely on software and PC hardware.
The system manufacturer, who assembles the interface board and other components to form
the overall system, and the system operator are responsible for compliance with the legal
regulations.
Reversing the polarity of the operating voltage of 5V at X1 can permanently damage
the module and is not a warranty case.
Connections
Status LEDs
No.
Description
3
Network traffic
4
Network Carrier (connected)
Supply voltage
(terminal X1 left)
No.
Description
1
Signal ground
2
+5V
