BeneVision TMS60, Operator'S Manual

Page: 102 / 250

Introduction Monitoring Noninvasive Blood Pressure (NIBP) (Optional)
10 - 2 TMS60 Operator’s Manual
10.1 Introduction
NIBP (non-invasive blood pressure) data is measured by BP10 using the oscillometric
method. This measurement can be used for adult and pediatric patients over three years
old. NIBP data is transferred from the BP10 to the TD60.
You can pair and unpair a TD60 with a BP10 via the Mindray Patient Area Network
(MPAN) functionality.
Once a TD60 is paired successfully with a BP10, measured NIBP data and NIBP-related
technical alarms will be displayed on the TD60 main screen. Besides, theTD60 allows you
to perform some operations on the BP10.
For the functionalities and operations of the BP10, refer to BP10 NIBP Module Opera-
tor’s Manual (P/N: 046-011008-00) .
10.2 Pairing the TD60 with the BP10
10.2.1 Pairing Procedure
Before pairing the TD60 with a new BP10, first unpair the already connected BP10 by fol-
lowing steps in
10.3.1 Unpairing via the TD60 .
To pair a TD60 with a BP10, follow this procedure:
1. Press the MPAN key on the right panel of the BP10. The“Pairing...” message will dis-
play in the message area of the BP10.
2. Press to enter the main menu of the TD60.
3. Tap Wireless Modules .
4. Switch on MPAN .
The TD60 starts searching the BP10 devices in the vicinity and displays the devices
that can be connected under
Devices . Make sure that the device you wish to con-
nect appears in the list of devices. If not, repeat Steps 1 to 4.
5. In the list of devices, select your desired device and tap Connect . Once the device
is connected successfully, the status will be changed from Disconnect to Con-
nected .
6. Start an NIBP measurement from TD60 to verify that desired BP10 module is
paired, and the NIBP measurement displayed on the BP10 are consistent with that
displayed on the TD60.