BeneVision TM80, Operator'S Manual

Page: 151 / 240

BeneVision TM80 Telemetry Monitor Operator’s Manual 12 - 15
◆
The Lead Placement menu is accessible by tapping an “ECG Sensor Off”
message in the alarm area.
◆
Ability to change display orientation.
◆
Hardkeys are enabled.
12.8.2 Setting the Screen Lock
The initial enabling of screen lock mode requires a passcode to be entered immediately as
follows:
1. In the Maintenance menu, tap Screen Lock to select a screen lock mode.
2. Enter a new passcode for the screen lock.
After the passcode is entered, the screen exits the passcode setup menu. The
selected lock mode displays to the right of
Screen Lock .
12.8.3 Changing the Current Screen Lock Passcode
1. In the Maintenance menu, tap Screen Lock .
2. Tap Screen Lock Passcode .
3. Input the current password.
4. Input and verify the new password
12.8.4 Changing the Screen Lock Mode
Follow this procedure to change the screen lock:
1. In the Maintenance menu, tap Screen Lock to choose a screen lock mode.
2. Select your desired screen lock mode and then enter a passcode.
12.9 Changing the Passwords
1. In the Maintenance menu, tap Edit Passwords .
◆
Tap Maintenance Password and follow the on-screen instructions to change
the maintenance password.
◆
Tap Service Password and follow the on-screen instructions to change the
service password.
2. Tap the icon to exit the Edit Passwords menu.
12.10 Changing the Device Name
1. In the Maintenance menu, tap Device Name .
2. Use the on-screen keyboard to input the device name.
3. Tap Accept to save the setting and exit the Device Name menu.