- 37 -
11. Guidelines for compliance with the environmental parameters of the
product
For the permanent environmentally friendly operation of the boiler it is necessary to follow the provisions of
these instructions exactly, especially:
•
burn only fuel with parameters guaranteed by the fuel manufacturer within the range shown in chart 3,
chapter 3
•
fully comply with the provisions of chapters 7 to 9
12. Instructions for disposal of the product after its service life.
Since the product is constructed of conventional metallic materials, it is recommended to dispose of individual
parts as follows:
- boiler body, casing
- through
KOVOŠROT company
- other metallic parts
- through
KOVOŠROT company
- SIBRAL insulation material
- general waste
- ORSIL T insulation material
- general waste
- TECHROCK insulation material
- general waste
13. Warranty and defect liability
The manufacturer warranties the boiler for a period of 24 months from the date of purchase to the
end user, provided it is used and operated in accordance with the conditions in this user
’s guide.
The boiler installation, commissioning and any troubleshooting exceeding the scope of chapters 7 and 8 must
be carried out by a qualified contractual service company which is accredited by BENEKOVterm Ltd, the
manufacturer of the boiler. Otherwise any warranty for the correct boiler operation is void.
The primary condition to acknowledge a claim against the warranty is that the boiler is connected to
the heating system so that the return water temperature into the boiler is monitored
AUTOMATICALLY and it is set to a minimum of
53 °C. This can be achieved by means of various
hydraulic connections depending on the boiler used. For more information
– see „Technical
documentation for installation of automatic boilers
“.
The heating project should be designed by a designer with knowledge of the complete heating
system.
If the boiler is used in accordance with this
„Boiler operating and installation guide“, no specialist service is
required.
„Certificate of quality and completeness of BENEKOV boiler” serves as “Warranty Certificate” after it is filled
in by the service company.
The boiler must be services regularly
– see chapter 8.
The manufacturer does not accept any liability for the loss of profit, good reputation or work nor any
accidental, special or consequential damage that arises in connection with the use or the
impossibility of use of this product.
Any notice of defects must be made immediately upon their discovery in writing and by telephone.
The boiler serial number must be stated whilst making a claim.
Summary of Contents for K14
