RBJ Series of Rolling Jacks
10
P/N 5900004 — Rev. D1 — October 2020
Setup
This section describes how to set up your Rolling Bridge Jack.
Safety Rules
When installing a Rolling Bridge Jack, your safety depends on proper training and thoughtful operation.
⚠
WARNING
Do not install this equipment unless you have installation training. Always use
proper lifting tools, such as a Forklift or Shop Crane, to lift heavy components. Do
not install this equipment without reading and understanding this manual and the
safety labels on the unit.
Only fully trained personnel should be involved in installing this equipment. Pay attention at all times.
Use appropriate tools and lifting equipment. Stay clear of moving parts.
⚠
WARNING
You must wear appropriate protective equipment during setup: leather gloves,
steel-toed work boots, eye protection, back belts, and hearing protection.
Tools
You may need some or all of the following tools:
•
Hex key wrench set
•
Medium crescent wrench
•
Forklift, Shop Crane, or other heavy lifting device
•
Medium flat screwdriver
•
Tape measure, 25 feet or longer
•
Air fitting, to connect the Air-Operated Hydraulic Pump to air pressure
Preparing the Lift
Rolling Bridge Jacks go into the open space between the two Runways of the four-post Lift.
Keep the following in mind:
•
The
Lift
must be installed properly and operating normally
. Only use a Rolling Bridge
Jack with a Lift that has been installed according to the manufacturer’s instructions and is
operating normally per those instructions.
⚠
WARNING
Do not set up or use a Rolling Bridge Jack if the Lift is not the model for which the
Rolling Bridge Jack was designed or the Lift was improperly installed. Instead,
contact the manufacturer of the Lift or BendPak Customer Service at (800) 253-
2363 for instructions.
•
The Lift must be lowered
. Before situating your Rolling Bridge Jack, fully lower the Lift or
engage it on its lowest Safety Lock position.
Tip
If you are going to be using a Crane to situate your Rolling Bridge Jack, you may need to
lock the Lift on the lowest Safety Lock position to make room for the legs of the Crane.
Summary of Contents for RBJ15000
