AV8OR User’s Guide
Aviation Mode Operation
System Setup Function
Pub. No D200803000008 Page 3-139 Rev 3 Apr 2009
© Honeywell International Inc. Do not copy without express permission of
Honeywell.
o
NAD27 (CONUS):
the NAD27 (CONUS) datum
•
Speed Units
: Sets speed units to
Knots
(nautical miles per
hour),
mph
(statute miles per hour) or
kph
(kilometers per
hour).
•
Distance Units
: Sets distance units to
Nautical Miles
,
Statute Miles
or
Kilometers
.
•
Altitude Units
: Sets altitude units to
Feet
or
Meters
. When
feet are selected, all altitudes are reported in feet. When
meters are selected, all altitudes are reported in meters.
•
Runway Length Units
: Sets runway length units to
Feet
or
Meters
. When feet are selected, runway lengths are reported
in feet. When meters are selected, runway lengths are
reported in meters.
•
Req Runway Surface
: The options are
Any
and
Hard Only
.
The Required Runway Surface type is also used when using
the DIRECT TO soft key to search for the nearest airports in
VFR Moving Map mode. When runway surface is set to ANY,
airports with either hard or soft runways are displayed. When
surface is set to HARD ONLY, only airports with hard surface
runways are displayed and soft-runway airports are ignored.
•
MIN R/W LENGTH:
This field contains the minimum length of
the main runway at those airports that are included when the
ten nearest airports are shown. Select the length field and use
set the minimum length value. The available values are
specified in steps of 100 feet from 0 to 16,000 feet or in steps
of 50 meters from 0 to 4900 meters when the runway length
units are set to meters. By setting a minimum length, airports
with shorter runway lengths are not included in the search for
the closest airport. To disable this filter set the minimum
runway length to 00000 feet.
Map Setup
The initial Map Systems Setup Options page allows different
mapping options to be configured. Refer to Figure 3-175.
