BendixKing
AeroPanel 100 Audio Selector Panel
Installation and Operator’s Manual
89000063-011
Page 1-2
Rev. 0, April 2020
A 3-light, 75 MHz Marker Beacon receiver is integrated in the AeroPanel 100. This provides the necessary
Marker Beacon lights and audio indications necessary for that portion of an Instrument Landing System (ILS)
approach. A pushbutton labeled MKR allows the pilot select high or low sensitivity as well as test and mute
modes.
In the AeroPanel 100, a Bluetooth® wireless interface is available for wireless telephone and music connec-
tion.
1.4
APPROVAL BASIS
FAA TSO Approval
The AeroPanel 100-series Audio Selector Panels are FAA approved under TSO C50c (Audio Amplifiers)
TSO C35d (Marker Beacon Receivers) and TSO C71 (DC to DC Converters, ETSO C50c/ and 2C53d.
All systems comply with relevant portions of EUROCAE RTCA MPS WG No. 7/70, DO-143 and (
Marker
Beacon Receivers
), ED-14C/DO-160C (
Environmental Conditions and Test Procedures for Airborne Equip-
ment
), ED12B/DO-178B, Level D (
Software Considerations for Airborne Equipment
) and ED- 18/DO-214
(
Audio Systems Characteristics and Minimum Operational Performance Standards for Aircraft Audio Sys-
tems
).
Operation is subject to the following conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
1.5
SPECIFICATIONS
TSO COMPLIANCE
Marker Beacon
:
FAA TSO C35d, Class A ETSO 2C35d
Audio Selector/Intercom
:
FAA TSO C50c, Class 1a ETSO C50c
USB Power Converter
FAA-TSO C71
APPLICABLE DOCUMENTS:
RTCA/DO-214 RTCA/DO-143 RTCA/DO-160D
RTCA/DO-178B DO-254
ENVIRONMENTAL Qualifications
:
A1D1CABSMXXXXXXZBABATBXXE2XXX
Operating Temperature Range:
-15º C to 55ºC
Altitude
:
Up to 50,000 feet in an non-pressurized area
DIMENSIONS:
Height: 1.3 in. (3.3 cm) Width: 6.25 in. (15.9 cm)
Depth behind panel 7.15 in. (18.16 cm)
WEIGHT
AeroPanel 100 Unit
Rack with connectors
1.34 lb. (0.61 kg)
0.51 lb. (0.24 kg)
POWER REQUIREMENTS
(Including Internal Lighting):
Voltage
:
11 to 33 VDC
Maximum Current
:
2.5 Amp (Externally protected by a 5A pull-type
breaker)
USB Charging Port:
Voltage - +5VDC
Current - 2.0A (10W Maximum) output, short circuit
and over-current protected
