Settings
Settings
iso685-x-B_D00177_07_M_XXEN/07.2019
39
9.2
(5.4.2) Automatic dimming
9.2
(5.5) Password
Use the password function to protect the device parameters against unauthorised adjust-
ment. The default password is 0000.
9.2
(5.5.1) Password
Enter an individual four-digit password.
9.2
(5.5.2) Status
Decide if the password query should be used:
9.2
(5.6) Commissioning
In the "Commissioning" menu you can open the ISOMETER®'s commissioning wizard
again. Pressing the commissioning button immediately starts the commissioning wizard.
After going through all the queried values, the new values are accepted by the device.
Press "ESC" to abort the process.
9.2
(5.7) Data backup
In the "Data backup" menu device settings can be saved or device settings already saved
can be restored.
9.2
(5.8) Activation
Activation of special customer profiles by Bender. The device is first configured by the
Bender service and the configuration is saved in a service profile. Activating this profile
causes a warning message. The customer can activate it as a customer-specific profile by
entering a
Service Profile PIN
. The warning message is then eliminated.
9.2
(5.9) Factory settings
Resetting the device to factory settings.
• on
Background lighting, POWER LED and button lighting are switched off after 3 min-
utes without operation and are only switched on again when any button is pressed.
Alarm LEDs light in the event of an alarm.
• off
•on
Password query active
•off
Password query inactive
•Save
The ISOMETER® saves your device settings.
•Restore
The ISOMETER® restores your initial or your saved device settings.
1. Profile:
Enter a 4-digit Service Profile PIN
9.2
(5.10) Software
9.2
(5.10.1) Update via interface
This must be active if a SW update is to be transferred from the web interface to the de-
vice via a BUF file.
9.2
(5.10.2) Update
Starts the update process after the BUF file has been transferred to the device.
9.2
(5.11) Service
Input Password
9.2
(6.0) Info
The ISOMETER®'s present settings can be viewed in the "Info" menu. Navigate through
the different views using the and buttons:
•Update via interface
Activates the SW update via web interface.
•Update
Starts update on the device. Alternatively, the update can
also be started via the web interface.
•Password
The Service menu can only be accessed by Bender Service staff.
•Device
Device name, serial number, article number
•Software
Software version measurement technology, software version HMI
•Measurement
technology
Selected profile, selected system type
•Clock
Time, date, summer time
•Ethernet
IP address, DHCP status, MAC address
•RS485
BS bus address; Modbus RTU address, BS bus mode
