Bender ATICS-2-63A-DIO, Manual

Page: 48 / 104

Operation
48 ATICS-DIO_D00080_01_M_XXEN/04.2015
6.2.3 Display in fault condition
There is an alarm message.

The yellow LED "Alarm" lights up.

Information about the message appears on the LC display.
Example: Line 2 has no voltage

Press the button "
↵
" to display the current alarm.
– Line 1: ALARM
xx = Serial number of the displayed alarm
yy = Number of pending messages
Use the arrow buttons "

,

" to select the previous or next message.
– Line 2: Alarm status and alarm text
– Line 3: Measured value
– Line 4: Address and channel of device triggering the message
If no button is pressed for a few seconds, the standard display reappears.

Press the "
↵
" again, then the main menu will appear.
The alarm text displayed in case of failure of one line depends on the setting in
the "System" menu in the "Settings menu 1: Changeover" on page 67.
If individual alarm messages are programmed on a TM… alarm indicator and
operator panel or on an MK… alarm indicator and test combination, the display
of this device may differ from the display of the ATICS® .
228V
50.0Hz
1 0 2
0.00V
0.00Hz
14:11
Undervoltage
228V
228V
1 0 2
0.00V
0.00V
228V
14:11
0.00V
Undervoltage
ATICS-2-DIO
ATICS-4-DIO
ALARM xx/yy
Undervoltage
0V
Addr.:3 Chan.:2