Installation and connection
25
ATICS-DIO_D00080_01_M_XXEN/04.2015
4.1.3
Removing the terminal covers
4.1.4
Mounting on DIN rail
1. Push back the locking hook (B) in the
middle of the top and bottom terminal
(A) cover by using a screwdriver.
2. Remove the terminal cover.
The photo shows ATICS-2-DIO.
The description also applies to ATICS-4-DIO.
1. Place the ATICS® on the top edge of the
rail.
2.
ATICS-2-DIO:
Use a screwdriver to pull
down the lower yellow slide lock (C) and
snap the ATICS® into place with slight
pressure.
ATICS-4-DIO:
Remove bottom green
plug connector. Use a screwdriver to pull
down the two lower yellow slide lock (C)
and snap the ATICS® into place with
slight pressure.
Check that the slide locks are properly
snapped into position by pulling slightly
the lower part of the enclosure.
3. Fix all terminals (C) with Allen screws,
including the terminals not currently
used.
Tightening torque: 5 Nm.
4. Fasten the terminal covers.
B
A
B
A
C
Summary of Contents for ATICS-2-63A-DIO
