Bender A-Isometer IRDH 275, Operating Manual

Page: 8 / 76

Safety information
8 TGH1361en/11.2009
This operating manual, especially the safety information, must be observed
above all by personnel who work on the A-ISOMETER
® .
In addition, the rules and regulations that apply for accident prevention at
the place of use must be observed.
1.2.1 Personnel
Only appropriately qualified staff may work on the A-ISOMETER ® . Qualified
means familiar with the installation, commissioning and operation of the
product and with training appropriate to the work.
Personnel must have read and understood the safety section and warning in-
formation in this operating manual.
1.2.2 About the operating manual
This operating manual has been compiled with the greatest possible care.
Nevertheless, errors and mistakes cannot be entirely ruled out. The BENDER
companies assume no liability whatsoever for any injury to persons or dam-
age to property which may be sustained as a result of faults or errors in this
operating manual.
1.2.3 Hazards when handling the A-ISOMETER ® IRDH275
The A-ISOMETER ® IRDH275 is constructed according to the state-of-the-art
and recognized technical safety rules. Nevertheless, when it is being used,
hazards may occur to the life and limb of the user or third parties, or there
may be adverse effects on the A-ISOMETER
® or on other valuable property.
The A-ISOMETER ® must only be used:
z
for the purpose for which it is intended
z
when it is in perfect technical condition as far as safety is concerned
Any faults which may impair safety must be eliminated immediately. Imper-
missible modifications and the use of spare parts and additional devices
which are not sold or recommended by the manufacturer of the devices may
cause fires, electric shocks and injuries.
Unauthorized persons must not have access to or contact with the A-ISOME-
TER®. Warning signs must always be easily legible. Damaged or illegible
signs must be replaced immediately.